SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

CO2 regulator trouble

707 views
4 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    February 2003
CO2 regulator trouble
Posted by kaimuki21 on Monday, May 25, 2009 3:37 AM
I have a CO2 tank with dual gauge regulator.  I have had problems with it in that the needle gauge vibrates when the valve is opened.  It didn't do that when I first used the system.  Had the regulator repaired but the problem recurred.  I even borrowed a friend's regulator and noticed that at first, it too worked.  Then when I used my airbrush (Iwata HP-CS) with the pressure about 15-20, the pressure started to rise when I didn't have the trigger depressed and the needle would rapidly rise off the scale.  I'd then hear the vibrating and rapid needle oscillations again.  I've stopped using it as I'm afraid I'm going to break my friend's regulator.  Any suggestions?  Is there something I'm missing with the hookups or setup?  Any advice would be appreciatetd.
  • Member since
    August 2006
  • From: Neenah, WI
Posted by HawkeyeHobbies on Tuesday, May 26, 2009 7:36 AM
Sounds to be an internal issue with the regulator. Contamination or a seal that has failed and is causing problems. Replace the regulator or have it rebuilt. Don't mess around with it, it can be potenially dangerous. Take it to a welding supply shop that sell such regulators.

Gerald "Hawkeye" Voigt

http://hawkeyes-squawkbox.com/

 

 

"Its not the workbench that makes the model, it is the modeler at the workbench."

  • Member since
    February 2003
Posted by kaimuki21 on Tuesday, May 26, 2009 8:59 PM
Thanks for the advice, thought it was something easy to fix but you're right.  I'm taking it to the CO2 people.
  • Member since
    July 2008
Posted by Firecontrols on Friday, May 29, 2009 12:04 AM
Glad to hear that your taking the valve and regulator in for inspection. CO2 tanks operate at very high pressures. A typical small CO2 tank is operating at anywhere from 860 to 1,000 psi, depending on the temperature in the room. Make sure that your valve has a safety release. At work, I've got photos of CO2 tanks that exploded and I would not have wnated to be near them when they popped off.
  • Member since
    February 2003
Posted by kaimuki21 on Friday, May 29, 2009 6:18 PM
Found out I was using a regulator set up for "flow" and not one for PSI.  The PSI regulators are like the ones used in aquariums and home brewing so I'm going to get the right ones.  I think that should solve the problem.
JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.