Enter keywords or a search phrase below:
Thanks all for the tips, will see what I can do.
PontiacRichLSP? Please explain!
Presunably he's referring to Tamiya's Liquid Surface Primer, which is similar to the finer grade Mr Surfacer.
MikeS71 Maybe try going over it with a light coat of LSP followed by an 800 grit then a 1200 grit...
Maybe try going over it with a light coat of LSP followed by an 800 grit then a 1200 grit...
LSP? Please explain!
Rich - "And when the Band you're in starts playing different tunes, I'll see you on the Dark Side of the Moon" - Pink Floyd
definitely need to prime it. or put a coat of future over it. otherwise it will always show through
800 grit is more than fine enough. that's what i use on my cars and it doesn't leave scratches.
I'll add that you should always "wet" sand, using progressively finer grades until the putty is nicely "feathered" down to the surrounding area. Hold the sanded area up to the light, tilt it at a slight angle and look along the seam for shadows or highlights indicating unevenness. Sanding seams/putty is one of those tasks requiring patience. Don't rush it , take your time and you will be rewarded.
Gerald (Hawkeye)'s article Reading the Seam may be of interest.
I could use some more sanding. If I putting an area I always prime it before painting.
Hey all
New to this stuff and cant figure out really what the problem is here, so thought I would see if anyone can help me out. Working on a turret of a 1/35 M41 Walker Bulldog. I put on a couple coats of Tamiya Spray Olive Drab and noticed the top half and bottom half had some bad fitting areas (this area of the bottom half jutted out a good ways). So I sanded it up (up to 800 grit) and puttied up the seam and tried recoating it with another 2 coats of OD. You can see the area to the right of one of the rungs. Is it just not enough sanding with a really fine paper? Thought I would check to see if anyone knew what my problem is before I ended up trying other stuff and ending up with 50 coats of OD on the turret
Thanks, Shane
Our community is FREE to join. To participate you must either login or register for an account.