SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

Bored with the ordinary looking Cases for your models?

1407 views
0 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    October 2019
  • From: New Braunfels, Texas
Bored with the ordinary looking Cases for your models?
Posted by Tanker-Builder on Friday, May 21, 2021 11:27 AM

Here's one I tried on a Bet!

         Some friends and I were talking about cases you could buy and how expensive some could be. I piped up and said," Well, those are ordinary Square ones too!",Says one friend," Well Smart A%% show us a different way then" Oho! a Challenge ! Never could resist one of those.

         So, we go into my shop(Body Shop) and I pull some Lexan off the shelf and cut two pieces with an arched top (Roman Simple Arch!) Then I cut another piece and take the plastic off both sides. " Whatya doin?" "You'll see". I go and get my Stainless panel bender ( A hollow Polished Stainless Pipe with caps on both ends and a water valve on each end as well. " Watch this boys!" says I.

   I proceed to fire up the boiler in the shop for this purpose. When the water has reached a "Roiling Boil"( I have a window in the side.) I fill the Stainless pipe. Set it on a rack and put the Lexan on it square. Within minutes the Lexan lying on this polished surface starts to sag. When it has sagged enough I remove it and put it over a wooden form and let it cool.

       I match the ends to the Curved Lexan and mark it for cutting. I cut it with a very slow Jig saw and then take it to the sanding table which in this case is a 48" across disc I bought used when a plastics supplier closed up shop. I placed it on there and made sure all was square and the polished the edges of the ends and Glued them in place. " There, says I, a case that's not like everyone else's"

 I took a piece of oak already prepared and placed this rounded top on it. They were certainly full of questions after that. Of course I had laid it out for cutting and forming later in the Week for a client's model. But, I proved there was more than one to make a case. I also proceeded to show them the piece I had in the office. A Mercury/Atlas rocket on the Launch Pad and the Lexan Pyramid that enclosed it. No one ever made that challenge again!

 

JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.