Revell Tornado GR.4, 1/48th # 04924. Instruction issue.

Hello, I am not sure about step #3, part T/1. My issue is the instructions placment for drilling out call out holes, normally the part to be drilled will have indents as to where to drill on the part but in this step they are calling out and pointing to drill locations that do not corespont to the part as there are no indent locations on 3 of the drill call outs, They are the first call out after the nose grear and the 2 side hole call out the mid section of the part. Anyone else encounter this?. I could drill and if wrong fill them in but where they call out is very close to part edge and could be difficult to repair. Thank you in advance for any help. Rory.