Hey nandman83,
Here are a few ways you could go about weathering your jug.
1. As a base coat use a
dark grey and NOT black(since the a/c is 72d). So when you go to apply your main colors(light coats though), the base coat will help add w/ the
"natural shadowing" effect
2. "Smudge wash". Before appling make sure you have a few coats of gloss on the a/c. Once this is all done, use a dark grey or a dark color of your choice(water based) and mix it w/ distilled water(ratio is up to you).
Apply it w/ a fine brush to the panel lines or areas you feel that you want highlighted. Let it sit for about
10 to 15 min.
Then go back over it w/ a
moistened Q-tips and wipe off any excess wash(leaving the wash in the panel lines).
You can repete the steps as many times as you like or till you get the look that you want(this was also in FSM awhile back by P Boyer).
3. Another way to weather is that you can use pastel chalk(gloss coat it before appling chalk,easier to remove).
Grind up the chalk that you want to use and brush it onto the areas that will experience weathering, exhaust stains, residue(sp
) from gun blasts, panel lines and the like. Just check w/ your references.
4. Or combined the above..!!
All of these steps may seem hard but they are actually easy to due. Hey if I can do it so can you
Seriously if you have any questions or if I did not explain a step clearly please feel free to e-mail me at
Falcon42177@yahoo.com
Flaps up,Mike
If you would listen to everybody about the inaccuracies, most of the kits on your shelf would not have been built Too Close For Guns, Switching To Finger