SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

Interior colour of StuG?

5494 views
5 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    November 2003
  • From: Ontario, Canada
Interior colour of StuG?
Posted by Copterguy on Monday, October 11, 2004 6:56 PM
Hi All,

So I just started putting together Tamiya's StuG III - the one with the little doggie mascot. Actually, my wife and kids were away for the weekend so I pretty much went at it for 14 hours straight - yeehaw! Anyhow, I'm hoping that someone might have the answers to a couple of colour scheme questions.

First, what colour should I paint the interior? I was just going to use something like panzer grey to tone down the yellow plastic so it's not visible through the hatches. However, what do I do about the interior side of the hatches? Are they grey, the factory applied dark yellow, or something else?

Second, I'm building an Eastern Front StuG with a dark yellow base / red brown camo paint scheme. What did the crews do as the season turned and the snow fell? Did they apply a white wash over top of the yellow/red brown camo? This is my first German tank so I'm not quite sure. Also, if they applied a whitewash, was it like the Allies - mopped on with whatever was at hand or sprayed on if you were lucky? Anyway, winter camo over top of summer might make for an interesting depiction of a well-used seasoned vehicle - I might try this if it was something that was done.

Any info would be terrific! Many thanks.Big Smile [:D]

Jim
Current Projects: Tamiya M1A2 Tamiya LRDG Chevrolet CWT 30
  • Member since
    December 2002
  • From: PA
Posted by JWest21 on Monday, October 11, 2004 7:00 PM
As for the interior, you want to get someone who pulled the pages off of AFVinteriors.com. I am not sure if they were Panzer buff or not.

You are right about the white wash. IThat's how they did winter camo and it was put on anyway they could. when the spring rains came, it washed off. Dwight Ta-ala has a really nice method of depicting whire washes

By the way, I have the same kit. Very nice,
Jason "There is a very fine line between "hobby" and "mental illness." -D. Barry
  • Member since
    November 2005
Posted by Anonymous on Monday, October 11, 2004 7:25 PM
As I recall German armor interiors were painted an off white called 'elfenbein'. I beleive Tamiya Buff XF 57 is often used by many modelers. It looks like the color of manila folders! This was applied to interior spaces.

I believe the underside of hatches were painted the same as the exterior color. That way from a distance one could not tell whether a hatch was opened or closed.

HTH
Glenn
  • Member since
    September 2004
  • From: Evil Empire ,Wainwright, AB, Canada
Posted by Strathcona on Monday, October 11, 2004 7:26 PM
Interiors of most German tanks were an off white ,ivory color. (White with a small amount of sand color added. Most models with no interior at all , I paint the inside of the hull , and turret , matt black,to give it depth , but it depends on the particular model ( how much can be seen through the open hatches , or if a crewman , is filling the hatch).As for the winter " white wash" , I like to use a water based paint , so I can rub it off , to show some wear. Some winter cam patterns , I have seen , appear to have been sprayed on , while many others were applied by brush , some rather sloppily.
Frank
" Perseverance"
  • Member since
    November 2003
  • From: Ontario, Canada
Posted by Copterguy on Tuesday, October 12, 2004 5:17 PM
Many thanks for the info folks!

Jim
Current Projects: Tamiya M1A2 Tamiya LRDG Chevrolet CWT 30
  • Member since
    November 2005
Posted by Anonymous on Tuesday, October 12, 2004 11:16 PM
Copter guy. The basic interior colour for your Sug 3 G Early is Elfenbein which is close to Tamiya's Buff, however the floor plates were usually green-grey or sometimes red primer. The transmission case and brake housings were green-grey, whilst the engine bay was left red primer on most vehicles.

For a period of 2-3 months in early 1945, Late version Stug 3 G's were not painted inside, the interior was left red primer. Your kit is not of a late version.

If you want to use the schurtzen in the kit, if you are keen, you might want to add zimmerit, as the stugs were issued schurtzen after the zimming process was standardised. Check out the stug Group Build thread for more info.
JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.