WHEEL RUTS FOR PLACING TRUCKS INTO BASE.

Wayne, I've been having the same problem. I've been building a lot of armor lately, and had mixed results getting them into the groundwork. On my next one I think I'll take a router and dig channels into the wood, as you suggested. 

 

Chris

For styrene or resin tires, I sometimes sand or file flat area on bottom.  For vinyl tires I use a touch to a sanding disk on a dremel.  I have also pushed styrene tires against a heated piece of metal, which bulges and flattens the bottom of the tire to show tire against a hard surface.

This worked for me recently.......building a diorama.......took some old tires connected with an axel made from a paper clip.......coated the base with "Durhams Water Putty"......let it set a bit......then ran the wheels over it to make ruts......dries hard........need to do some pre-planning to get the ruts where the finished vehicle will be located......vary the pressure to vary the depth....can re-coat with putty where you goof......

If using modeling clay, while it is still pliable, place the model you are using onto it and gently press it down until you get the desired sunken effect. Then remove and detail the clay accordingly. This will leave you with perfect ruts that look natural and form exactly around the tire. If doing rut tracks, do the same but across the whole area. You could also take just one of the wheels and roll it across the clay while applying force to acheive the desired effect.