Yep, I'm asking it again...

I'm using an Iwata HP-BC2 that I've had for over 20 years. I don't even know if they make it anymore. The original tip and needle and I can still get a line as fine as hair. The only item in your wish list it does not perform is a wide spray, otherwise it's there. I haven't looked at the new types for lack of need, but I'm a firm believer in 'love the one you're with', so I personally would check out Iwata.

QUOTE: Originally posted by jfrejo Try the Omni or Iwata eclipse line. I would stay away from single action brushes as double action ones are much better.

I'd never say they were "better" but they are different.

For a beginner, the single action brush seems to allow for an easier level of control over the spray. Even now - 15 years and a bit into my painting, I still prefer to use the single action almost half the time. For model painting, there simply isn't as great a variety of situations where the full potential and advantages of a good double action will be found.

Just look for a decent brush, and a decent compressor and then PRACTICE. You can think of a good airbrush like a musical instrument. If you get a Stradivarius, but never practice, what good is it? But yet the student on their cheap hack fiddle can make beautiful music because they have practiced and know what a fiddle will and won't do. See the point here?

Anyway, I'd spend a LOT more time worrying about the model you're building, rather than the shiney new chrome finish of brand X airbrush. The most important thing is to enjoy whatever you get, and even more to enjoy the freedoms it offers you as far as finish goes.

Best!

Brian~

hmmm omni, badger, iwata.

Try the Omni or Iwata eclipse line. I would stay away from single action brushes as double action ones are much better.

I think the short answer is simply: Any one you're happy with! I've got an ancient double action Mark1AF-1011 and a beat up single action Paasche model H from back in high school. They both get the job done. I've never replaced the needle in the Mark1 and apart from cleaning both brushes, I've never had to replace or repair any parts.

http://www.mark1airforce.com/item31264.ctlg

http://www.paascheairbrush.com/single_action_airbrushes.html

The beauty of airbrushing to me (both in modeling and in graphic design and illustration) is that its such a simple instrument both in use and design. There are a minimal of moving parts and clean-up is usually quite easy.

Anyway...I'd suggest trying as many as you might be able to get your hands on. I think the biggest thing for me was the feel of the thing in my hand. Weight and balance are probably the biggest thing for me. One thing to watch for though, if you don't have a reasonably steady hand, you'll want to get a color cup with a lid! ;)

Bri~