What do I need to connect my TC-20T compressor to a Badger Anthem?

GMorrison

 

 

Phil_H

Or if you want to go the other way and use your existing Badger air hose, you just need one of these adaptors to connect it to the compressor.

http://www.amazon.com/Badger-Air-Brush-Airbrush-Compressor-0-25-Inch/dp/B000BQ093Q

 

 

 

 

 

Thats what I did, and I got it from the swell folks at Badger.

 

BTW I am a "gravity fed" man. Just find it easier to clean, less parts, less places to get problems. Kind of like a screw driver versus a pair of scissors (WTF???)

 

Not only is it easier to clean but you can spray at lower pressures for smaller mottling. I use my Badger hose with an adaptor for Ewatas. Works just fine.

Phil_H

Or if you want to go the other way and use your existing Badger air hose, you just need one of these adaptors to connect it to the compressor.

http://www.amazon.com/Badger-Air-Brush-Airbrush-Compressor-0-25-Inch/dp/B000BQ093Q

 

 

BTW I am a "gravity fed" man. Just find it easier to clean, less parts, less places to get problems. Kind of like a screw driver versus a pair of scissors (WTF???)

Or if you want to go the other way and use your existing Badger air hose, you just need one of these adaptors to connect it to the compressor.

http://www.amazon.com/Badger-Air-Brush-Airbrush-Compressor-0-25-Inch/dp/B000BQ093Q

One of these  will do:

http://www.amazon.com/Master-Airbrush-Conversion-Airbrushes-Connector/dp/B0038NNUIA