SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

Changing From Lacquer Thinner to Turpentine In My Brush Cleaning Jars

1443 views
9 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    February 2003
  • From: Where the coyote howl, NH
Changing From Lacquer Thinner to Turpentine In My Brush Cleaning Jars
Posted by djrost_2000 on Friday, April 22, 2016 6:00 PM

I have three Silicoil brush cleaning jars that are now full of lacquer thinner, and will soon be full of turpentine or turpenoid.  Will let jars air out for a time before adding turps.  Any chance the residue from the lacquer thinner could interact with the turps?  Should I wash the jars out with soap and water or can I just pour the turps into the jars?

Dave

  • Member since
    February 2003
  • From: Where the coyote howl, NH
Posted by djrost_2000 on Friday, April 22, 2016 9:11 PM

Never mind, throwing out the old jars.  Problem solved.

Thank you,

Dave

 

  • Member since
    August 2007
  • From: back country of SO-CAL, at the birth place of Naval Aviation
Posted by DUSTER on Friday, April 22, 2016 10:42 PM

djrost_2000

Never mind, throwing out the old jars.  Problem solved.

Thank you,

Dave

 

 

Sorry you’re so far away, ya could toss 'em in my direction, as I drive by

 

Seriously; just dispose of the lacquer thinner as required and give the jars a soap/water rinse and you are good to go.

 

 If you have residue on the coil, let it dry and use a soft brass or stiff bristle brush to remove most of it; It won't harm the thinner.

 

For those not familiar, the thinner is reusable; only the sediment needs to be removed every so often -left to dry and then thrown out with the trash.

 

 

Steve

Building the perfect model---just not quite yet  Confused

  • Member since
    February 2003
  • From: Where the coyote howl, NH
Posted by djrost_2000 on Saturday, April 23, 2016 3:38 PM

Duster, thank you!

Dave

  • Member since
    June 2014
  • From: New Braunfels , Texas
Posted by Tanker - Builder on Sunday, April 24, 2016 9:39 AM

Gee ! I was going to suggest the same thing.I usually clean my jars when I get too much sludge on the bottom .This means filtering the material as I decant .Why ? Well the thinner is perfectly good .

     Now there's a cleaning screen in the jar . I took a screen and formed it to the jar inside and fill it till there's about a half of an inch of thinner over the bottom of the screen . I get good clean brushes this way .

    If you have twist on caps you do need to punch a tiny hole so the material can breathe . Otherwise if it accidently gets shaken , it can pop the top off !  T.B.

  • Member since
    February 2003
  • From: Where the coyote howl, NH
Posted by djrost_2000 on Sunday, April 24, 2016 10:40 AM

Tanker, thank you.

Right now I'm using Silicoil brush cleaning jars which have a spiral metal coil inside to press the bristles against, and get out the paint.

TY,

Dave

  • Member since
    November 2009
  • From: Twin Cities of Minnesota
Posted by Don Stauffer on Sunday, April 24, 2016 11:20 AM

I don't think there is any residue from lacquer thinner.  That stuff is so volatile it will be all evaporated in a day or two.  Good paint thinner, like mineral spirits or turpentine, will also leave no residue.  Only that cheap synthetic "paint thinner" they sell today- that whitish tinted stuff leaves a residue, so I don't use it, I stick to stuff that specifically says mineral spirits or turpentine.

I have not seen any crud sold as lacquer thinner yet, but I suppose some will turn up one of these days.  When that happens I will become more selective and only use MEK or Acetone.

Don Stauffer in Minnesota

  • Member since
    June 2014
  • From: New Braunfels , Texas
Posted by Tanker - Builder on Sunday, April 24, 2016 4:55 PM

Hi;

   I have heard of them , but , never seen them where I could buy them . T.B.

  • Member since
    June 2014
  • From: New Braunfels , Texas
Posted by Tanker - Builder on Sunday, April 24, 2016 4:57 PM

Hey Don :

 I second that .Now If I buy lacquer thinner I get it at the Commercial paint supply in San Antonio . Remember , I do still run Minshipco .  T.B.

  • Member since
    February 2003
  • From: Where the coyote howl, NH
Posted by djrost_2000 on Sunday, April 24, 2016 6:59 PM

dickblick art supplies has them.  Select "B", click on Brush Cleaners, select Silicoil cleaning tank (it's just a medium size jar).

Thank you Don.  I've opted to get new jars anyway, I'm just going to take the old jars directly to recycling, also won't have to worry about getting old metallics in my colors for figure painting.

TY,

Dave

 

JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.