Hi Deek and Welcome to the Forum. If you want a sharp demarcation line at wing to fuselage on a 190, best way is to mask it with tape, even though it is difficult to match the panel. Best advise is to use a fairly flexible tape, like Tamiya, but slice a thin strip off the main tape. Use a very sharp , new X-acto blade and a steel straight edge. Cut on a hard surface, plate glass is ideal, and make the strip about 1/8" wide and about an inch or more longer than you need. Then carefully apply the tape at the juncture line you want. You can trim the excess length, and add more strips above the masked edge until you have enough area covered to prevent overspray where you don't want it. The mottle (dots) on luftwaffe AC takes practice, but if your getting splatter you are probably spraying at too high a pressure, or your paint is too thick, or both. Try thinning your paint to at least 2 paint/1 thinner. Set your pressure no higher than 15 psi and
lower if you can get paint flow. Hold the brush close to the model ( 1/4'' or so ) and spray in short, even bursts. With a little practice you should be doing mottle like a pro.
RICK
At My Age, I've Seen It All, Done It All, But I Don't Remember It All...