MM Acrylic 'Cure Time' question

Not exactly precise, but you can try the "sniff test" - if you can smell solvent, it's still out-gassing and not fuly cured.

Gloss colours may take considerably longer to cure because they form a less permeable skin compared to "flat" colours (thanks Ross ).

Caliberx wrote:

MikeV wrote: ...to keep the heat in and a model is completely dry and ready for clear coating or decaling in a matter of hours    Sorry ti bring up an oldie but I have a question specific to this statement.  How can you tell that the paint is completely dry or cured?  Is there a way to check or is it based on experience? Thanks Vincent

Is the paint dry?-Usually I have painted spruce or unexposed plastic that I can touch to test.  As far as cured-that's more of a matter of experience.  I try to let my final coats (acrylic) cure at least 24 hrs before applying Future and then another 24 hrs before decals.

Your mileage may vary.....

MikeV wrote:

...to keep the heat in and a model is completely dry and ready for clear coating or decaling in a matter of hours

Sorry ti bring up an oldie but I have a question specific to this statement.  How can you tell that the paint is completely dry or cured?  Is there a way to check or is it based on experience?

Thanks

Vincent

Let me reiterate that, you can use a hair dryer to speed the drying process but you must keep it moving over the model and not let it get too hot or you can experience the problems IYAAYAS mentioned.

What I prefer is a drying booth that anyone can make for very little money and it works fantastic.

My thanks to Greg (Plasticmod992) for letting me know about this a year or so back.

Here is mine. It is nothing more than a cardboard box lined with aluminum foil and a 100 watt lightbulb. I hang a towel over the front fastened with two clothes pins to keep the heat in and a model is completely dry and ready for clear coating or decaling in a matter of hours....(Not sure of the exact times as it's been a while since I used it).

Maybe Greg can provide some input here for us? Greg?  

Thanks all.  I won't have a chance to sand until Wed. pm at the earliest (72 hrs) so that should be good.

Thanks again.

Humidity plays a huge factor in cure time.  If you keep your model in a non-temperature controlled area in South Florida, then 48 hours is not enough.  If you're in the desert of Arizona, 24 hours is more than enough.

Watch using a hair dryer to cure paint...you'll be amazed at how quick plastic warps at even low heat...unless your totally crushed for time, avoid the hair dryer, or any other form of artificial heat.

Triarius wrote:

Unless you force dry/cure. Even then, 24 hours.

Well said Ross. Use a hair dryer and cure it real good and 24 hours should be just fine.  

Unless you force dry/cure. Even then, 24 hours. 

Bob,

I would wait 48 hours and then sand and repaint.