Question about my Badger 360. Paint leaking out.
Guys,
Can anyone help me with this? My AB is fairly new and when I use it it sprays fine but, I have a lot of leakage around the fitting just forward of the cup. I have hand tightened as much as I can and it still happens all the time. I have looked online and at the schematic provided with the brush and I don't see and O-rings or what-not that may be missing and or bad. Also before I start spraying, the cup is "bubbling" like air is back flowing through it.
I guess I could contact Badger directley but I was hoping if anyone here could give me a little help.
BTW, I spray Tamiya acrylics as well as MM enamals through it and have the same problems with both. And my operating pressure is around 18-25 PSI.
Any help would be appreciated.
Regards,
Jeff