help

Heres how I apply my decals.
1. spray the model with a glosscaot (i use future floor polish)
2. when its dry, I cut out the detail and put into a bottle cap filled with water (might need a bowl for the larger decals.)
3. after around 10-20 seconds I remove the decal from the water with tweezers.
4. I then place the decal as close as possible to the area that it needs to go.
5. then, slide the decal off the backing paper and position it. ( use a toothpick and/or a paint brush (came from a crayola watercolor set) )
6. once the decal is in position, push out all air bubbles with a toothpick.
7. Finally I cover the decal in some solvaset and then when its all dry I seal the model up with a dull coat.

I usually put the decal in the water until the backing paper slides off by itself.
for 1/72 models that i love, I usually brush Future on the decalling spot and when the future is dry, i put the decal on it.
when the decal is dry, put it under a clear flat coat.

Thank you for the help with decaling i must buy some Future and will use you help i will post after the job id done letting you know how it went
my Thanks to
John $ Jinithith2
------Fatman----