No!!!!

hee hee hee I remember things.... Bwwhahahahaha

Ah, it's not that bad. Worse things have happened. It could have actually been on your finger for hours

Congratulations, you have survived your first encounter with a phenomenon known to modelers world wide.  It's the fabled "Black Hole of Modeling".  It exists anywhere modelers and models exists.  It can be on your bench, under your bench or even between the bench and the floor.  It's function appears to be to cause model parts, pieces and even modeling tools (all of the smaller variety) disappear from this plane of existence thereby causing immense frustration to the modeler.  It also appears to have a sense of humor.  It has been known to make a part disappear and then wait until the modeler has gotten an new part by A. getting a new part from the mfg after a 6 week wait or B. spending 10 t0 15 hrs scratchbuilding the a new part.   Either way, 2 to 10 minutes after the new part is installed on the model, the origional part will appear RIGHT IN THE MIDDLE OF YOUR DESK!  This usually results in a period of even greater frustration on the part of the model.  All I can say is to be prepared - you will meet this phenomenon again many times in the future.  Good Luck

Note:  It is also widely believed the Black Hole of Modeling also has a brother/sister which resides in every mechanical washer/dryer in the world.  This relative seems to remove 1 sock from 1 pair in each load of laundry washed or dried.