SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

After sanding defects out of primer

835 views
2 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    April 2020
After sanding defects out of primer
Posted by Foxy on Friday, June 19, 2020 10:44 AM

Advice need.. It seems after spraying my body panels with primer some water has some how got into the parts and ruined it in several spots.. So my question once I've sanded the defects out what is the usual procedure... Re prime the entire part, prime the defect area, or just go ahead with a colour coat? Thanks in advance

  • Member since
    September 2012
Posted by GMorrison on Friday, June 19, 2020 10:47 AM

I'd probably spot prime it. Try a couple of ways to see what works.

 

Bill

 Modeling is an excuse to buy books.

 

  • Member since
    September 2006
  • From: Bethlehem PA
Posted by the Baron on Friday, June 19, 2020 12:37 PM

Foxy, I second Bill's advice, especially over just proceeding to apply your color coat over that spot.  Better to have primer down, than not, in my experience.  And it's certainly possible and easy enough to re-prime that spot, than to do the whole piece over.

The bigger the government, the smaller the citizen.

 

 

JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.