I'm curious to hear from others with opinions or build experience who have built the Kinetic 1/48 A-6A/E. This is my first Kinetic kit and second overall since returning to the hobby after 20 or so years. I just started the build and so far I'm finding many ill fitting parts and less than clear instructions/drawings.
I started with the cockpit and the tub required quite a bit of carving and adjusting to get it to fit right in the fuselage. The fuselage bottom center section took quite a bit of fitting as the tabs holding it were too long not allowing a tight seam and too thick not allowing a flush fit. The radome is going to require lots of sanding/blending for a good fit to the fuselage. The canopy, yikes, I'm not sure any amount of sanding/carving is going to make this look right. So far just about every part or assembly I've touched has needed adjusment and fitting.
Is this typical for Kinetic kits, this Kinetic kit in particular or did I just get a lemon. I'm about to put it back in the box and write it off.
Randy