Enter keywords or a search phrase below:
No, the background needs to be painted 'instrument panel' color. The dial faces themselves could be painted white
On the bench: Revell-USS Arizona; Airfix P-51D in 1/72
Okay, a plain transparent sheet will still work, though you will have a glossy black panel rather than a flat black one. However, if you are a good hand painter you can carefully paint around the instruments with flat black. Also, adding toggle switches is pretty easy. Drill a small hole at switch location with a pin vise and cut a piece of fine wire. Glue the wire(s) in the holes. I find it easier to cut the wire longer (easier to handle) and cut them to length after the glue sets.
Craft stores like HL and Michaels carry some great wire for these, in the beading sections. It is a fine copper wire plated to look like chrome.
Don Stauffer in Minnesota
Thanks all. That is a good review, keavdog.
keavdog The problem with this kit is the front piece is a clear flat piece with no relief
The problem with this kit is the front piece is a clear flat piece with no relief
"You can have my illegal fireworks when you pry them from my cold, dead fingers...which are...over there somewhere."
Looks like you may have an out of production example, judging from the product number. The Eduard site doesn't generate any hits.
If you look at the instructions for the current product
https://www.eduard.com/out/media/fe232.pdf
you can see that you are to sandwich the photo film between several PE pieces. Do you have those PE parts? Or were they not included in the OOP detail set?
Thanks,
John
There should be two pieces of the panel, a back piece and a front piece. Glue the decal to the back of the front piece with a transparent glue or white glue, being careful to register it so that the dial faces line up with holes on the front piece. Then glue it to back piece with white glue. Do NOT use solvent glue for either step.
I have this kit as well and did a bit of poking around on the web and found this review on modelingmadness https://modelingmadness.com/review/korean/cleavermig15preview.htm
My only real complaint is the instrument panel. This is done as a "sandwich" of an opaque part, with a photo-print panel like an Eduard kit, and a clear part to go over it - the problem is that the clear part has no engravings for the instruments, which will make painting around the instruments a bit difficult. I am sure I will make my own panel to go over the photo-print from .010 Evergreen sheet.
Cut it out and usually sandwhich between the IP and a PE overlay
I have never seen a decal like this. This is for Trumpeter's MiG 15 bis Fagot B. The instructions refer to it as "film". It is not your clasic decal on paper but is a transparent soft plastic sheet.
How do I us it? Do I cut it out or the classic dip in water way?
Our community is FREE to join. To participate you must either login or register for an account.