This week the diorama base for the Stuka is being built up. The base is a 16” diameter, 1/8” thick maple base. I started by painting the base with forest green and dirt tan in patches. Using the Scene-O-Rama accessories the base was sprayed with spray glue and sprinkled with the medium green and dark green “grass”. I then added some “weed clumps” and added some “yellow flower” spots on the weeds. A sheet of thin styrene was then trimmed to fit one edge to be part of the runway. I used medium gravel to trim the edge of the runway and sprinkled a few “rocks” around the base. The area where the aircraft and vehicles sit was then scraped to show bare spots.
I then assembled the Kettenkraftrad. I painted it the dark green with leather seats. It was then weathered using black, dark gray, light gray, and mud brown pastel chalk. Once the vehicles and aircraft are mounted on the base I will add bits of grass and dirt to the wheels and tracks. I was looking over the figures and one of them shows a mechanic kneeling holding a tool. With the height of the aircraft engine off the ground I searched the internet and located a few photos of Stuka’s being worked on. They all show a maintenance platform with a sandbag keeping the wheels stable.
Using the photos I scaled out the size of the platform. I then used styrene rods to make up the frame and sheet styrene for the steps and platform. I then scaled out the wheels and sandbag. These were then put into Solidworks and finally 3-D printed. The platform was then painted medium gray and weathered. I then built up a couple of jerry cans and fuel drums to add to the display. Next I will be working on all the figures that will be used.