Hello All,
Maybe some of you more experienced folks can see what is supposed to happen here.
Part MA1 is a PE part, but I am not sure how it should fit, or what the point of it is. Part b11 fits snug against the side of the hull, and perfectly flush with the top of the hull, but part MA1 is a little over-sized to fit on top of it; it is going to either hang out a little over the top of the hull, or hang out a little on both the long sides. Part K11 fits on top of b11 just fine.
From all I can see, the PE part will be all but covered up by K11, except for the little bit that does not quite fit. So, I am not sure what this PE screen is supposed to represent, or how it should fit, or if it will be visible at all, which would beg the question of why it is included.
Anyone have any ideas how this should go together?
Thanks!
PS - This kit is going together fairly well. The instructions can be a little difficult to follow, but so far has been a fun kit, with only some small fit issues.