cockpit harness

I use the tape method all the time and really like it. Here is a tip, the tape takes paint very well. I paint mine Testors wodd and then dry brush with a light sand or tan. Works fo rme.

Brent

Yeah, I have cut way back on 1:32.  Current 1:32 project (using masking tape belts, too) is a racer (Laird-Turner) so it is pretty small for a 1:32.  It isn't scratchbuilt (except for interior- I trashed the whole kit interior and did it myself).  In general though I am moving towards smaller scale.

Thanks Don, I've been playing with that very idea and getting some very good results. I wish I could afford to build in the 1/32 range but  the truth is I just dont have the space for it.

icit

I do it one of two ways.  Sometimes I double it over, creasing along the centerline, then cut to width.  I do that mostly in larger scale, like 1:32.  For smaller scale I often just cut a stripe out of the tape (tape pressed against a cutting mat.  The single layer then has adhesive back to stick it to seat.  For small scale I use PE fittings.  For 1:32 I often bend fine craft wire into fittings.

Also, for 1:32 (the double layer method) I run the strip through the buckle and double back upon itself to create the "adjustable" section.  For the smaller scale I usually dispense with the adjustment piece.

Masking tape has a color very close to one of the colors of the old military belts.