Enter keywords or a search phrase below:
You never know. it can't hurt, so they should do it.
A little liquid dish soap and water, a good rinse.
Modeling is an excuse to buy books.
OK, thank you.
Washing resin is always good,a good scrubbing if possible.Also priming helps when painting.
Thank you again.
Be super careful if you do any sanding or sawing on resin parts. The dust can be very irritating to the lungs. A good respirator is essential.
Jim
Main WIP:
On the Bench: Artesania Latina (aka) Artists in the Latrine 1/75 Bluenose II
I keep hitting "escape", but I'm still here.
Plastic styrene glues won't work, need CA's or epoxy.
If you are not experienced with cyanoacrylate CA (aka super glue) the best procedure is to pre-fit the parts twice to make sure they fit properly. Take the CA glue use a very little and smooth it out as thin as possible put the part in straight in to position and hold it for a second as the glue hardens. It is now attached.
Chasing the ultimate build.
OK. Thank you all very much, Guys.
Our community is FREE to join. To participate you must either login or register for an account.