Need Help with Airbrush

Patrick and Phil,

Thank you for the info.....I am going to check both.

It could be as simple as your needle not being fully seated at the "at rest" position.

It may also be helpful to get into the habit of starting your airflow with the airbrush pointed away from your model, then bring it to bear before starting the paint flow.

MM68

Some guys report having better luck at 20-25 lbs, might not help you if there is a problem with the AB, but worth a try.

Patrick

Andrew and Pete,

Thank you for responding.....at the time the air pressure was at 15 psi and the needle is straight and clean. The entire gun was clean. Did a full detail clean after last time I used the gun.

Could be low air pressure. .bent needle.? .needle seat out of shape. ??..sounds like too low of air pressure. .or it could be a bad O ring in the tip ..hope that works out. Pete 

I think it's likely you have a cracked nozzle,  if you are lucky its just dirty.  What is your air pressure?