Hey Friends, been awhile since I posted here....so much going on, so little time these days.
Anyway, I hope some knowledgable person can assist me here. I have an Iwata Revolution HP-CR (gravity feed) that has been very good to me up until a few days ago. For about a month now the needle has been difficult to remove after sitting for a couple of days, despite proper clean up after each use. Worse then that and most recently, when I fill the cup with paint, it seems to bleed down and settle in to the nozzle cap. I probably don't need to tell you but this can cause all kinds of grief, as the excess paint that settles in the cap splatters upon triggering the airflow ruining a good paint job.....ARGH! Any suggestions on a fix would be most appreciated.
Thanks,
John