Okay, before someone posts the link, I've already read "The Complete Future" on Swanny's site about a dozen times, and it's wonderful.
However, I used Future for the first time last night to cover an a/c before decaling, and it looked a little odd. The Future went on very heavy, and I had my PSI set to about 15 or so. I had a lot of run off, and I turned the model on end to let it drip off, as I was worried about it pooling in low spots.
Now, is this something I need to be afraid of, or will it level itself out? I've been using Testors Glosscote, and it looks similar when going on (heavy and wet and initially looks too heavy but then once it dries it looks fine). Just need to make sure I'm doing it right.