How do I do soft-edged camo schemes?

I've gone as far as base coating my model in the secondary color and rolling sone "non-hardening" modeling clay into snakes about 3/16" in diameter and placing them as I thought looked good then sprayed my main color over that. That way you don't need to free hand and you get more of an idea of what it will look like.

QUOTE: Originally posted by chester111472 Thanks for the input....what PSI do I need to use? Chad

I shoot at around 15-20, but other people may shoot differently. That has worked for me, though. Also, if you use masks, shoot at a 90 degree angle to the mask, or you'll get overspray under the mask. :)

Thanks for the input....what PSI do I need to use?
Chad

QUOTE: Originally posted by Bgrigg Pickup the October issue of FSM, Matthew Usher has a very good article on this very subject! Basically it consists of cutting shapes in a card material and holding it just above the area to be sprayed.

That's what I do for all my camouflaging now (I'm not very good at freehand) and it works quite well, as long as your pressure's down. Does NOT work with rattlecans...too much paint in too small of a space.

I use the technique first sugested(cut outs held just above the surface) and then go back "freehand to extend the design. I also suggest you weather and matte seal between color coats. This will give a "deeper" feel. Take your time! Let things dry between application or you'll end up with a sticky mess!!! The colors and designs changed quite a bit through out the war, so make sure to start with the right scheme for the time and place that you are reproducing. Reference!Reference!Reference! and don't forget that different materials "age" and weather at different rates; ie.metal cables,rubber,etc. dirty it up for the real deal!!!
and finally remember the little stuff counts! You're gonna spend the time so don't let a little thing throw it all off. The first thing your fellow hobbist look at is the little stuff.

Good Luck and have fun!

for soft edge camo I do it free hand. to reduce overspray I hold the AB at or close to a 90 degree angle to the model surface and apply light coats.

Low air pressure, get the airbrush up close and personal with the model and paint. Angle into the color to reduce excess over spray. Unles syou hav a documented vehicle you're replicating, there's no need to draw the pattern or cut out patterns, etc.

Hey Chad,
There are lots of answers to this question. German camo is pretty easy because really nothing is wrong. Early war is very easy because everything was gray

For later war WWII patterns, the colors are important. Dunkelgelb, Rotbrown, and Green??. The schemes are mostly random (except when they are ordered by the commander to adhere to some kind of division pattern) and are usually some form of the ambush scheme and can be with or w/out the "leaves". It's really easiest to go by a picture and try to keep it close to that.

For painting itself, here is my order. Primer, preshading, dunkelgelb base coat, draw the pattern lightly with a pencil, then the red and green, then blend with extra thinned dunkelgelb again to clean up overspray.

Alot of people just spray away without drawing the pattern and get excellent results.

Here is my finished Puma with the technique I just described. I didn't use a reference picture. It's just random.

Pickup the October issue of FSM, Matthew Usher has a very good article on this very subject!

Basically it consists of cutting shapes in a card material and holding it just above the area to be sprayed.