After reading a post somewhere the other day, I think I experienced moisture buildup in my AB hose.
I was camo'ing my doomed Do335, and I could not get a consistent paint flow for anything. I was using Model Master Acryl Dark Green and my Iwata Revolution. I've used several other Acryl paints with no trouble. This time I'd get the paint to flow for maybe 20 seconds and then it would start to stop up. I'd clean the tip and it would get a bit better but slow down again. At times I'd have the trigger pulled back halfway with hardly any paint coming out, and then GUSH, here comes the paint, but it looked a bit thinner and more transparent than I had mixed in the brush. I couldn't get any fine lines at all.
What does everybody think? Moisture buildup or something else?
And on moisture traps, what is required to be done with them, if anything, other than open the valve on the bottom every few minutes and blow out the water in it?
Thanks for any help-
Bruce.