Decals rolling!

How do I apply the decal? cover the whole wing at one time? and then trim the overhang.
What do they mean about Rib Strips (where's the B.B.Q. lol). I reall y want to apply the lozege decals, looks like it would make a neat model. Roden doesn't really give a lot of info with their kits.

Any tips would be appreciated!

Thanks,

Ion Engine.

Mark;
I went back to it with a wet brush and got them to sit down pretty well. Thanks for the reply.
Steve

I always get a bit nervy when this happens. My usual reaction is to take the decal off and put back in the water to clean off the Micro-sol and clean it off the model, then put the decal back on the model and reapply the sol very sparingly.

I have had decals that have rolled themselves into a ball that I have resurrected. Takes a long time and patience. If its really bad I'll get it straightened out in the water dish, slide the old backing paper back under it so I can lift it out without any curling and re-place on the model. I'll use a tissue or something really absorbent to remove any water then apply heat (hair drier) rather than the Micro-sol.

How has it gone since you asked the question?