Okay so after a little bit of time, I've finally got enough done here on this rudder and horizontal stabilizer/elevators to post. I scratch built all of this since it was absent on the kit. Here goes:
image by brittvallot, on Flickr
Here is a view of the elevators. They've been cut and dressed up a bit. I plan on putting her in a dive when I mount it so it requires me to adjust their position.
image by brittvallot, on Flickr
Here is a view of one completed. I wanted to show both so I left one unglued for the time being.
image by brittvallot, on Flickr
image by brittvallot, on Flickr
These two show a detail of the trim tab actuator.
image by brittvallot, on Flickr
Here's the rudder. I've added the rudder horn and trim tab actuator (other side). Also the rod that allows it to rotate is visible and often not molded correctly. So here I cut out the space for it and included it. Also, I needed to build up the interior since it will be somewhat visible as it's no longer molded to the fuselage.
image by brittvallot, on Flickr
I poked a very tiny hole here from underneath to place a very small diameter brass rod (I'll check the size later) in place and glued it down with CA to secure safely.
image by brittvallot, on Flickr
image by brittvallot, on Flickr
So here you can see a detail of the brass rod making up the rudder horn and trim tab.
I have a little bit of mess to clean up here. It's one of the things I do my best to avoid but inevitably it happens.