SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

/41 Willy's Hot Rod

1155 views
3 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    November 2005
/41 Willy's Hot Rod
Posted by Anonymous on Wednesday, August 6, 2003 7:35 PM
I was building a '41 Willys, and putting the breathers on top of the engine. Any tips for a new modeler about gluing butt joints like this? I'm trying to avoid using too much glue, and I want it to look clean (mine doesn't). Any help out there?
  • Member since
    January 2003
  • From: Foothills of Colorado
Posted by Hoser on Wednesday, August 6, 2003 9:11 PM
Super Glue.
"Trust no one; even those people you know and trust." - Jack S. Margolis
  • Member since
    February 2003
  • From: USA
Posted by Holley on Thursday, August 7, 2003 11:22 AM
Like Hoser said, Super Glue. You can use an accelerator to dry the glue instantly.
I found a spray bottle of it at my hobby shop. Just be careful as it will harm some paints.
Holley When all else fails, read the instructions!
  • Member since
    February 2003
  • From: USA
Posted by FITTER on Thursday, August 7, 2003 5:32 PM
You might try drilling a small hole on the underside of the breather and a corresponding hole in the valve cover. Use a small piece of brass wire (or a piece of a straight pin) held in place with 5-minute epoxy or cyanoacrylate. It can be applied from the underside so as to be inconspicuous. Not only will this method present a neat appearance, but the small parts will remain where they belong.

FITTER
IBTL
JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.