SEARCH FINESCALE.COM

Enter keywords or a search phrase below:

A Kickback to-Doubling Down

155 views
0 replies
1 rating 2 rating 3 rating 4 rating 5 rating
  • Member since
    October 2019
  • From: New Braunfels, Texas
A Kickback to-Doubling Down
Posted by Tanker-Builder on Saturday, July 23, 2022 5:58 PM

Just thought I would add this!

             When I was going through a way to make a more traditional Wheelhouse for the H.O. Lakes Freighter, I ran into a problem that fell right into this suggestion. Well I  just thought I would let you know how I solved the problem.

             The Port and Starboard(Right and Left Respectively) back corners on the plans showed Round corners I did this. I put a doubler on both sides on each piece needing to be joined I then added another piece(A tripler?) that stuck out the thickness of the wall of a quartered plastic tube of the right diameter. Then Glued the tube's inside edge to the edge sticking from the bulkhead pieces. Viola! A nice rounded corner that took very little sanding after the glue dried.

       So! Sometimes it's the same idea with Mods, Right? I am a firm believer in proper support but staying within scale looking product!

 

 

         

JOIN OUR COMMUNITY!

Our community is FREE to join. To participate you must either login or register for an account.

SEARCH FORUMS
FREE NEWSLETTER
By signing up you may also receive reader surveys and occasional special offers. We do not sell, rent or trade our email lists. View our Privacy Policy.