Moving right along!
Engines are simple enough. I added stretched sprue as a backer for the wiring rig, and bent some wire, to go from the short wire rig on up to where it belongs.
The landing gears are nice little gems, but somewhat of a PITA! The fender being the most difficult. The only attachment points are a tiny PE strip that wraps the fender.
For the wing/boom assembly, the instructions would have you first attach the bottom outer wing half to the outer boom half, then attach the top two pieces, while sandwiching the flap and aileron. Then you install the engine and gear, then the inner boom half.
To make the sanding process easier, I glued up the booms, just to the rear of the gearbay. This way, they could be split apart to install the gear and engine. Booms were warped.
When I cemented these to the inner wing top, I cemented the rear portion on both sides, but only the outer boom half was cemented all the to the front, allowing the parts to still be pulled apart.
The outer wing portions were cemented together along with the control surfaces and......... clear wingtips, kinda silly feature! It took a bit of brutality and finess at the same time to make them fit the rest of the wing.
Sorry Manny, this one just can't knock Accumins TBF off the top shelf!!! I'd rank it somewhere in the middle, not GREAT, but not BAD. I'd build another someday!
Should be throwin paint in a day or two!!!