1/48th Scale Saturn V

Now for the four segments going between the fin shrouds. 

All four glued to the main tube.

Two of them.

Now using 1 mm. stringers I began gluing them down using CA.

With the fin loosely attached. 

Using the same pattern, I made marks at the bottom and pinholes at the top of each shroud. Then using masking tape I connected them. 

End result. 

Using the pattern from the kit I simply traced four of these on a single tube.

I had tried using a tube of the same diameter as a mandrel and using a heat gun managed to remove some of the warping. However, the results didn't straighten them out entirely. I canned them and chose to build them from scratch. 

Three of the four resin fin shrouds were warped from the manufacturer.

Not all pieces will be used for this.

Pieces from New Ware.

Unfortunately, I'm presently getting '403 forbidden errors' when trying to change my avatar or posting from my own files. 

I would love to see this!